How long can a log run with the logger module?
There is no limit from the DataDisplay.
The only limit is the storage of the medium used, but even here, with continuous logging, many months will pass before the storage is full.
Every log gets an increment at the end of the file name.
AK-NG-Log1.csv, AK-NG-Log2.csv, AK-NG-Log3.csv, etc....
So that a log does not become too large to be quickly uploaded to e.g. Datazap.me, logs are rewritten with an additional number at around 5MB.
E.g. AK-NG-Log3-1.csv, AK-NG-Log3-2.csv, AK-NG-Log3-3.csv, etc.
FAQs From Same Category
First check whether a new bootloader is online. If yes, update this:
Under: Settings - System - System Info you can see the bootloader version and the display (application) version.
The first update with a laptop requires the driver to be installed:
ownload and unpack the driver package.
It's best to use "C:\NextGen_usb_driver" for example, problems can occur if the path is too long or there are spaces in the path.
Run zadig_2.2.exe
Under “Device” click on “Load Preset Device”.
Select the "ak-motion.cfg" which is also in the driver archive
If your own image does not differ from the one shown here, press “Install Driver”.
Next you need the update program:
Unpack NextGen-Updater.zip
Run AK-NG-Updater.exe
Click on “Settings..” and change “Interface selection:” to “XCP on USB”.
Confirm with OK
This setting remains saved once it has been made.
Die Updates befinden sich hier
We recommend this simple program to connect to the display via the USB cable:
Connect the DataDisplay NextGen to the PC using the USB cable
Start the "HTerm" program.
Apply the following settings as shown in the picture:
Port: The port is different for everyone. If there are several to choose from, unplug the DataDisplay, click on the "R" button to the right of the port selection and see which port has disappeared. Reconnect the DataDisplay, click "R" again and select the port for the DataDisplay
Baud: 115200
Data: 8
Stop:1
Parity: None
Press the "connect" button at the top left and the connection to the display will be established.
Under "Input control" check the Ascii only box.
Type: ASC
Enter the command "reset" in the input field (as shown in the picture) and press Enter on the keyboard.
The display is now set to factory settings and restarts.
In most cases it is because the plug is plugged in the wrong way round either in the connection box or in the display. This means that the power supply is guaranteed, but not the CAN bus for the data.
Solution: Insert the cable the right way round (flat side to flat side and round side to round side).
The flickering means that the bootloader is active and can accept an update.
If the display runs for some time, the bootloader is told that the application is ok and running.
The actual software (application) is then started immediately and the display no longer flickers when switched on.
If you frequently turn the ignition off and on again, it flickers again because the application hasn't run long enough.
This is a safety feature so that the display can always be updated should something go wrong.