Oil pressure sensor

M12x1.5 thread. Suitable for most models as a replacement for the oil pressure switch or using a Y-adapter.

Cable length 2.5 meters

Cable assignment:
White: signal (connection to A1 on NextGen)
Black: ground (connection to GND)
Red: power supply (connection to 5V)

Note:
Update of the NextGen display to version 1.41 Beta5 or higher is recommended. Here you can select different sensors under "Settings - External - Analog A1 Setup". Selection: AK-Motion Sensor

If the plug is too big for the position in the engine compartment, the hard plastic on the plug can be carefully (!!!) removed at this position: